More Update

 

• Program an overshoot mode in the set servo function that catches the buzzing
• Put in some notes on left turn with high/low capacitance or what have you
• Segmentation fault if wrong baud rate!
• Add two button press to change upper and lower bounds and write to file on exit mode
• Make the serial data port very very simple
• Perhaps use the onboard serial port
• Figure out how to get it log in remotely over wifi
• Set up a system to configure upper and lower bounds of the servo (rate one turns)
• Split the status check for minimum navigation, position, and garmin aviation string
• Perhaps include something for waypoints (started)
• Perhaps include a wide and a narrow band for the coupler - single pole flip switch?
• Pull apart the old coupler and test it on the old servo and capacitor
• fiddle with the resistors to balance the brightness of yellow and green LED
• Figure out some kind of case with the buttons and lights mounted
• wipe out old log files every now and then (shell script on setup should do)